Desa Td125, Td126, Td127, Td128 Continued, Do Not Light Heater, Sliding Manifold and Burner

Assembly

Continued

9.Thread manifold to bottom of burner assembly (see Figure 9). Tighten with wrenches (see Figure 10.)

10.Temporarily connect hose and regulator to manifold. Connect hose and regulator to a 20 lb. propane cylinder.

DO NOT LIGHT HEATER!

Open propane cylinder valve. Leak test burner assembly and manifold connection using a noncorrosive leak detection fluid.

DO NOT USE FLAME. See Checking for Leaks, page 8. When there is no sign of a leak, turn off propane/LP cylinder valve and disconnect regulator from propane/LP gas cylinder. Slowly loosen connection between manifold and hose and regulator assembly. Propane gas left in hose will escape.

11.Remove bolts from burner assembly. Carefully lean base and pole assembly over and insert manifold and burner assembly through pole (see Figure 11).

Replace bolts.

12.Remove blue film from dome top. Dome attaches to burner assembly with three

5/16" nuts and six 5/16" washers.

Place 1 washer on each threaded stud of burner assembly. Place dome over studs. Attach 3 washers and nuts to studs. See Figure 12.

Burner

Assembly

Manifold

Burner
Assembly	Bolts
	Removed	Manifold
	From Here
		Pole
	Bolts Reinstalled
	Through Here

Figure 11 - Sliding Manifold and Burner

Figure 9 - Attaching Manifold to BurnerAssembly into Pole Assembly

Figure 10 - Tightening Manifold and

Burner Assembly

Figure 12 - Attaching Dome to Burner

Assembly

121117-01Bwww.desatech.com