Desa Td125, Td126, Td127, Td128 Tools Required, Attaching Wheels to Base, Base Assembly

Assembly

Tools Required:

•1) #2 Phillips Head Screwdriver

•2) Adjustable Wrenches

Hardware packet provided with heater may contain more parts than needed for heater assembly.

1.Attach wheel assembly to base using two

5/16" bolts, two 5/16" washers and two 5/16" nuts (see Figure 1).

2.Attach legs to base using two 1/4" bolts, four 1/4" washers, two 1/4" lock washers and two 1/4" nuts per leg (see Figure 2). Place washer on bolt then insert bolt through leg and into top of base. Attach

5/16" Bolt,

Washer

and Nut

Base

Wheel

Assembly

Figure 1 - Attaching Wheels to Base

1/4" Bolt

and Washer

Pole

Support

1/4" Washer,

Lock Washer

and Nut

Legs

Base

1/4" Washer,

Lock Washer

and Nut

Figure 2 - Base Assembly

washer, lock washer and nut from under- neath base. Finger tighten only. Repeat for each bolt and leg. Do not fully tighten until next step.

3.Secure pole support to legs using two 1/4" bolts, four 1/4" washers, two 1/4" lock washers and two 1/4" nuts per leg (see Figure 2). Repeat for each leg. Wrench tighten nuts and bolts from step 1 and 2.

4.Remove 4 bolts and washers in collar of pole support (see Figure 3). Place pole over pole support collar. Reattach and tighten 4 bolts and washers.

5.Attach back cover using four 1/4" large Phillips head screws and four 1/4" wash- ers as shown in Figure 4.

Pole Pole Support

Bolt and

Washer

Figure 3 - Pole to Pole Support

Back Cover

1/4" Large

Phillips Head

Screw and

1/4" Washer

Figure 4 - Attaching Back Cover

121117-01Bwww.desatech.com