Desa Td125, Td126, Td127, Td128 WARNING If you smell gas Shut off gas to the appliance

Locating Heater

WARNING: Do not move heater when lit. Allow heater to cool before moving.

1.Locate pop-out wheel decal on base of heater (see Figure 15).

2.Standing on decal side of heater, care- fully lean heater away from you to access wheels underneath base.

3.Swing wheels out from under base to relocate heater.

4.Replace wheels underneath base after placing heater in desired location.

Pop-out

Wheel

Decal

Figure 16 - Locating Heater

Wheel

Figure 15 - Pop-out Wheels

Operation

WARNING: If you smell gas:

•Shut off gas to the appliance.

•Extinguish any open flames.

•If odor continues, immediately call your gas supplier.

See safety warnings and pre- cautions starting on the front page of this manual for more information.

PREPARING FOR OPERATION

1.Check heater for possible shipping damage.

If any is found, immediately notify dealer.

2.Follow all safety information starting on page 2.

3.Check and assure control knob is in the

OFF position.

4.Place propane/LP gas cylinder inside cylinder base. Securely connect regulator to propane/LP gas cylinder.

5.Turn cylinder valve on. Apply a noncor- rosive leak detection fluid to connection at regulator and cylinder. Bubbles forming show a leak.

6.In case of any leaks, turn off propane/LP cylinder valve, undo leaking connection.

Check and clean connection. Reconnect regulator and leak test again.

IMPORTANT: On new installations or routine gas cylinder changes. The system must be purged of air before use. Turn control knob to the pilot setting. Press and hold for 30-40 seconds before attempting to light pilot.

121117-01Bwww.desatech.com