What type of batteries should be used for the remote control unit?

Use only alkaline batteries in the remote control unit.

How do I attach the terminal wires to the 9-volt alkaline battery?

Simply attach the terminal wires to the 9-volt alkaline battery and place it into the battery housing.

Open the bottom louver and locate the switch bracket on the left.

FIREPLACE INSTALLATION

Installing Optional Wireless Hand-Held Remote Control - (C)GHRCB and (C)GHRCTB Series

FIREPLACE INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL - (C)GHRCB AND (C)GHRCTB SERIES

Installing 9-Volt Alkaline Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to a 9-volt alkaline battery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

1.	Open bottom louver and locate the switch bracket on the left.
2.	Unscrew the switch bracket. Lean bracket forward so you are
	able to access the back of the remote receiver.
3.	Locate the battery clip mounted on the back of the receiver.
	Slide a 9-volt alkaline battery (not included) through the clip
	(see Figure 37).
4.	Attach the terminal wires to the battery.
5.	Remove wire from TH to TPTH on control valve (see Figure 37).
6.	Connect wires from receiver to TH and TPTH to control valve