Desa (V)V36P-B SERIES, VV36PC1 SERIES For Your Safety Read Before Lighting, To Turn Off Gas

OPERATING FIREPLACE

For Your Safety Read Before Lighting

Lighting Instructions

To Turn Off Gas To Appliance

Manual Lighting Procedure

25

OPERATING FIREPLACE

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

9.Turn on all electric power to the fireplace.

10.Turn gas control knob counterclockwise to “ON”.

11.This valve is equipped with a HI/LO feature. Set fireplace input as desired.

12.Close lower louver panel.

	Gas Control	Variable Control Knob
	Knob
Piezo
Ignitor	ILOT	IH
	F	O
	P
	F	N

B.	BEFORE LIGHTING smell all around the appliance area				O
					LO
	for gas. Be sure to smell next to the floor because some gas
	is heavier than air and will settle on the floor.			Figure 52 - Control Valve
	WHAT TO DO IF YOU SMELL GAS
					TO TURN OFF GAS
	•	Do not try to light any appliance.
	•	Do not touch any electric switch; do not use any phone			TO APPLIANCE
		in your building.		1.	Open lower louver panel.
	•	Immediately call your gas supplier from a neighbor's
				2.	Set selector switch in the OFF position to prevent draining
		phone. Follow the gas supplier's instructions.
C.	Use only your hand to push in or turn the gas control knob.				battery.
				3.	Turn off all electrical power to the appliance if service is to
	Never use tools. If the knob will not push in or turn by hand,
	don't try to repair it, call a qualified service technician. Force				be performed.
	or attempted repair may result in a fire or explosion.			4.	Push in gas control knob slightly and turn clockwise
D.	Do not use this appliance if any part has been under water.				to “OFF”.
	Immediately call a qualified service technician to inspect			5.	Close lower louver panel.
	the appliance and to replace any part of the control system			Shutting Off Burners Only (pilot stays lit)
	and any gas control which has been under water.
		LIGHTING		You may shut off the burners and keep the pilot lit by doing one
		INSTRUCTIONS		of the following:
1.	STOP! Read the safety information above.			1.	Turn gas control knob clockwise	to the PILOT po-
					sition.
2.	Open lower louver panel.
				2.	Set selector switch in the OFF position.
3.	Turn off all electric power to the fireplace.
4.	Push in gas control knob slightly and turn clockwise				MANUAL LIGHTING
5.	to “OFF”.				PROCEDURE
	Wait five (5) minutes to clear out any gas. Then smell for			1.	Remove glass door (see Removing/Replacing Glass Door,
	gas, including near the floor. If you smell gas, STOP! Fol-
					page 22).
	low “B” in the safety information above. If you don't smell
				2.	Follow steps 1 through 8 under Lighting Instructions.
	gas, go to the next step.
6.	The pilot is located by the main burner and should not re-			3.	Depress gas control knob and light pilot with match.
	quire accessing for lighting.			4.	Keep gas control knob pressed in for 30 seconds after light-
7.	Turn gas control knob counterclockwise		to “PILOT”.		ing pilot. After 30 seconds, release gas control knob. Fol-
8.	Push in gas control knob all the way and hold. Immedi-				low steps 10 through 14 under Lighting Instructions.
	ately light the pilot by repeatedly depressing the piezo spark			5.	Replace glass door (see Removing/Replacing Glass Door,
	ignitor until a flame appears. Continue to hold for about				page 22).
	one (1) minute after the pilot is lit. Release gas control knob
	and it will pop back. Pilot should remain lit. If it goes out,
	repeat steps 5 through 8.
	• If gas control knob does not pop up when released, stop and
		immediately call your service technician or gas supplier.
	•	If the pilot will not stay lit after several tries, turn the
		gas control knob to “OFF” and call your service techni-
		cian or gas supplier.
		For more	visit www.		.com

111252-01E