Cast Iron Stove And Direct-Vent Burner System Assembly

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Stove Body Assembly

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

STOVE BODY ASSEMBLY

1.Lift off corrugated box enclosing stove body crating.

2.Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from plastic-bagged stove body. The bottom pieces of pallet wood will remain bolted to the stove body.

3.Remove plastic bag from stove body.

4.Remove back panel from stove (see Figure 6). Use an adjust- able wrench or a 10 mm socket. Remove six (6) bolts and wash- ers. Keep bolts and washers to reattach back panel later.

5.Remove all contents from inside stove cavity. Contents include:

(1)- Stove bottom (Discard. Not used in this application.)

(4)- Legs with leg leveler bolts

(1)- Bottom door

(1)- Top grate

(1)- Hardware kit bag with fasteners

6.Carefully lay stove body on back to attach bottom components to stove body (see Figure 7). Rest stove on drop cloth or blan- ket to avoid scratching stove edges.

7.Remove remaining pallet wood attached to bottom of stove body (see Figure 8). Use an adjustable wrench to remove bolts.

Bolt	Product
	Product
	Identification
Back	Label
Stove
Panel
Figure 6 - Removing Back Panel
Top of Stove Unit	Front of	Top of
Front of	Front of	Top of
Stove	Stove Unit	Stove
Unit		Unit

Drop

Cloth/

Blanket

Pallet Wood Bolted to Bottom of Stove Body

Figure 7 - Laying Stove On Side

8.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figures 9 and 10). Use an adjustable wrench or a 12mm socket.

9.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Figure 9 and Figure 11 on page 7). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.