VLAN Port Configuration

Use this screen to configure port-specific settings for IEEE 802.1Q VLAN features.

 

Figure 3-29. VLAN Port Configuration

 

 

Parameter

Description

PVID

The VLAN ID assigned to untagged frames received on this

 

port. Use the PVID to assign ports to the same untagged VLAN.

Acceptable Frame

This switch accepts “All” frame types, including VLAN tagged or

Type1

VLAN untagged frames. Note that all VLAN untagged frames

 

received on this port are assigned to the PVID for this port.

Ingress Filtering1

GVRP Status2

GVRP Failed

Registrations2

GVRP Last PDU

Origin2

If set to “True,” incoming frames for VLANs which do not include this port in their member set will be discarded at the inbound port.

Enables or disables GVRP for this port. When disabled, any GVRP packets received on this port will be discarded and no GVRP registrations will be propagated from other ports.

Note that GVRP must be enabled for the switch before this port setting can take effect. (See Configuring Bridge MIB Extensions on page 26.)

The total number of failed GVRP registrations, for any reason, on this port.

The Source MAC Address of the last GVRP message received on this port.

1This control does not affect VLAN independent BPDU frames, such as GVRP or STP. However, it does affect VLAN dependent BPDU frames, such as GMRP.

2Note that GVRP is not implemented in the current firmware release.

36 Configuring and Monitoring the Switch

DNswitch 800

Page 46
Image 46
Digital Networks North America DNswitch 800 manual Vlan Port Configuration, Pvid