Dolby Laboratories HT2030 Connections Continued Basic TV Connections, Optional TV Connections

Connections (Continued)

Basic TV Connections

Use one of the following connections, depending on the capabilities of your TV.

RF coaxial connection

Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on your TV using the supplied 75-ohm Coaxial Cable (R).

ote

If you use this connection, tune the TV to the DVD+VCR’s RF output channel (CH 3 or 4).

How to set the DVD+VCR’s RF output channel

While the DVD+VCR is turned off, press and hold CHANNEL (v/V) on the front panel for about five seconds to change the RF output channel to CH 03 or CH 04. “RF 03” or “RF 04” will appear on the front panel display.

Audio/Video connection

1	Connect the DVD/VCR VIDEO OUT jack on the
	DVD+VCR to the video in jack on your TV using the

supplied video cable (V).

2 Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on your TV (A) using the supplied audio cables.

ote

If you use this connection, set your TV’s source selector to VIDEO.

Rear of TV

ANTENNA	AUDIO INPUT		VIDEO	COMPONENT VIDEO INPUT			S-VIDEO
INPUT			INPUT				INPUT
	L	R	L	Pr	Pb	Y

R A V C S

Rear of DVD+VCR

Optional TV Connections

otes

The S-VIDEO OUT and COMPONENT VIDEO OUT/PROGRESSIVE SCAN connections are for DVD playback only! The tuner and VCR will still be output through the RF.OUT (R) or DVD/VCR OUT (A, V) jack.

When using the COMPONENT VIDEO OUT/PRO- GRESSIVE SCAN jacks, set the VIDEO OUTPUT switch to COMPONENT/PROGRESSIVE. When using the S-VIDEO OUT jack, set the VIDEO OUT- PUT switch to S-VIDEO.

S-Video connection

1	Connect the S-VIDEO OUT jack on the DVD+VCR
	to the S-Video in jack on your TV using the supplied
	S-Video cable (S).
2	Connect the Left and Right AUDIO OUT jacks on the
	DVD+VCR to the audio left/right in jacks on your TV

using the supplied audio cables (A).

Component Video (Color Stream®) connection

1	Connect the COMPONENT VIDEO OUT jacks on
	the DVD+VCR to the corresponding in jacks on

your TV using optional Y/Pb/Pr cables (C).

2 Connect the Left and Right AUDIO OUT jacks of the DVD+VCR to the audio left/right in jacks on the TV (A) using the supplied audio cables.

Progressive Scan (ColorStream® pro) connection

If your television is a high-definition or “digital ready” television, you may take advantage of the DVD+VCR’s progressive scan output for the highest possible video resolution.

If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD+VCR.

1 Connect the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks on the DVD+VCR to the corresponding in jacks on your TV using option- al Y/Pb/Pr cables (C).

2 Connect the Left and Right AUDIO OUT jacks of the DVD+VCR to the audio left/right in jacks on your TV (A) using the supplied audio cables.

otes

–Set “Progressive” to “On” on the DVD setup menu when using the progressive signal (see page 23).

–Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).

12