Drolet ECO-35 Electrical Diagram, Electrical diagram, Components left side, Electric Shock

ELECTRICAL DIAGRAM

THERMOSTAT HOPPER LID

TERMINALS SWITCH

N.O.N.O.

CONTROL

BOARD

THERMISTOR

DISPLAY BOARD

L2(LINE COMMON)

L1(LINE HOT)

L1(LINE NO CONNECTED)

FRAME GROUND

L-250

RESET

N.C.

AIR FLOW

PRESSURE

SWITCH N.O.

L-250

N.C.

L-250

N.C.

F-160

N.O.

COMBUSTION/EXHAUST AUGER IGNITER

BLOWERMOTOR

CONVECTION

BLOWER

Figure 26

Electrical diagram

CONVECTION			HIGH TEMPERATURE
		AUGER	SWITCH L-250
BLOWER		MOTOR	AUTOMATIC
PRESSURE	CONVECTION	CONVECTION
SWITCH	BLOWER	BLOWER	HIGH TEMPERATURE
	FRESH AIR	EXHAUST	SWITCH F-160
	INTAKE
	POWER		AIR SUPPLY
			CONTROL
	CORD
THERMISTOR
CLEANING	THERMOSTAT	EXHAUST/COMBUSTION	IGNITER
ACCESS	TERMINAL	BLOWER	HIGH TEMPERATURE
PANEL
			SWITCH L-250
			MANUAL RESET

Figure 27
	Figure 28	Figure 29
Components left side
	Components rear	Components right side

ELECTRIC SHOCK

In order to verify the grounding and polarity of the power outlet, the control board sends a low voltage impulse to the stove’s frame.

If the polarity is wrong or if the outlet is not properly grounded, you may feel an electric shock when you touch the stove; this low voltage impulse is harmless and connecting your stove to a grounded outlet with the right polarity will keep this from happening and protect your electronics against damages from power surge.

26