Drolet ECO-35 Stove Installation, Back wall installation, Corner installation Floor protection

STOVE INSTALLATION

ECO-35 FREESTANDING PELLET STOVE

Width: 22 1/4”

Height: 28 1/2”

Depth: 25 3/16”

Weight: 190 lbs.

Flue size: 3” or 4”

Hopper Capacity: Up to 35 lbs.

(This can vary slightly depending on pellet size, length, and diameter) EPA status: exempt

Burn rate: 1.3 lbs to 4.1 lbs per hour

BTU range: 8,200 to 35000

Electrical consumption: 3.5 Amps lighting cycle

2.5Amps. continuous duty

Control board fuses: Main: 7.5A-250V fastblow

Igniter: 5A-250V fastblow

Electrical requirement: 120VAC 15A

Approved installations: mobile home, conventional

PREPARATION

Factory packaging must be removed, and some minor assembly work is required prior to installation :

•The black knobs must be attached to heat exchanger rods

•The coil handle must be attached to handle rod

CLEARANCES

The ECO-35 has been tested and listed for installation in regular and mobile homes.(refer figure 1 & 2)

FLOOR PROTECTION: minimum 6” in the front and 6” on each side. The stove must be placed on a continuous (grouted joints) non-combustible material such as ceramic tile, cement board, brick, 3/8” millboard or equivalent, or other approved or listed material suited for floor protection. NOTE: ceramic tile, or any tile, requires a continuous sheet beneath to prevent the possibility of embers falling through to the combustible floor if cracks or separation should occur in the finished surface, this would include floor protection for Built-in raised hearths. Check local codes for approved alternatives.

Clearances are measured from the sides, back and face (door opening) or stove body (refer to fig. 3).

DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE INSTALLATION OF THIS UNIT.

INSTALL VENT WITH CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.

This heating unit must serve as a supplementary heat source. An alternative heat source should be available in the home if needed. The manufacturer cannot be responsible for additional heating costs associated with the use of an alternative heat source.

It is highly recommended that the user buys this product from a retailer who can provide installation and maintenance advices.

BACK WALL

3"

	2" *
WALL	6"
SIDE

Figure 1

Back wall installation

ADJACENT WALL

2"	3"
	3"
	ADJACENTWALL
	2"

Figure 2

Corner installation

6"	6"
	6"

Figure 3

Floor protection

6