Drolet ECO-35 Thermostat Wire Terminal, D = MINIMUM DISTANCE 15 FEET, Thermostat Installation

OPERATING THE STOVE USING A THERMOSTAT

A thermostat may help you maintain a constant house temperature automatically. A millivolt thermostat or 24 Volt thermostat is required. A fixed wall mount or hand held model can be used. The control panel can be set up two ways to operate your stove in thermostatic mode.

THERMOSTAT INSTALLATION

•Unplug the stove from the power outlet.

•Connect two thermostat wires to the terminal block located on the lower right side of the back of the stove. To do so, loosen the two screws and insert the wires in the terminals. Tighten the two screws. (See Figure 15)

•If you are using a wireless wall thermostat or a hand held thermostatic remote control, you can locate the receiver behind the stove’s back panel, on the right end side, just below the terminal block. Most receivers are already equipped with quick-connect terminals. Simply unplug the PC board wires connected to the back of the terminal block and connect them directly with the receiver’s terminals. Location of the thermostat is very important to obtain the best comfort and efficiency from you ECO-35. The thermostat should be mounted 50 inch from the floor on a wall located 15 to 20 feet from the stove. You should avoid an installation directly in front of the stove to avoid cycling.(See Figure 16)

MODES

THERMOSTATIC MODE

•To use this mode, the thermostat button must be pushed upon starting the stove. The heat setting is then selected using the “Heat Level” selector. When set in thermostatic mode, the stove will automatically run at the heat level selected until the set room temperature is reached. When that occurs, the stove will switch to heat setting #1 (lowest) until the thermostat calls for heat again. The convection blowers will also slow to its lowest speed. When the thermostat calls for heat again, the stove will increase its feed rate to match the heat setting selected.

•N.B.: If the room temperature remains stable and the thermostat does not call for heat during at least 45 minutes, the stove will shut down. When the thermostat calls for heat again, the stove will start an ignition cycle. Once the ignition cycle is completed, the stove will increase its feed rate to match the heat setting selected.

NOTE: When in thermostatic mode:

•You should not operate the manual control or play with the temperature setting.

•YOUR THERMOSTAT SHOULD BE INSTALLED BY AN AUTHORIZED DEALER OR SERVICE PERSON.

15

THERMOSTAT

WIRE TERMINAL

Figure 15

Thermostat terminal

SHOULD BE AVOIDED

D = MINIMUM DISTANCE 15 FEET

Figure 16

Thermostat location