Dukane 8110H user manual Image menu, For no signal

IMAGE menu

IMAGE menu

From the IMAGE menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor (or the ENTER) button to execute the item. Then perform it according to the following table.

Item

Description

	Using the ▲/▼ cursor buttons switches the mode for aspect ratio.
	For a computer signal
	NORMAL ó 4:3 ó 16:9 ó 16:10 ó NATIVE
	For a video signal, s-video signal or component video signal
	4:3 ó 16:9 ó 16:10 ó 14:9 ó NATIVE
ASPECT	For no signal
	4:3 (fixed)
	• The NORMAL mode keeps the original aspect ratio of the signal.
	• The on-screen menu might be displayed outside of the image display
	area depending on the adjustment value of the ASPECT, D-ZOOM
	and KEYSTONE. Changing the values of ASPECT, D-ZOOM and
	KEYSTONE may fix the symptom.
	Using the ◄/► cursor buttons adjusts the over-scan ratio.
	Small (It magnifies picture) ó Large (It reduces picture)
OVER SCAN	• This item can be selected only for a video, s-video and component
	video signal.
	• When this adjustment is too large, certain degradation may appear at
	the frame area of the picture. In such a case, please adjust small.
	Using the ◄/► cursor buttons adjusts the vertical position.
	Down ó Up
	• Over-adjusting the vertical position may cause noise to appear on the
V POSITION	screen. If this occurs, please reset the vertical position to the default
	setting. Pressing the RESET button on the remote control when the V
	POSITION is selected will reset the V POSITION to the default setting.
	• When this function is performed on a video signal or s-video signal,
	the range of this adjustment depends on the OVER SCAN (above)
	setting. It is not possible to adjust when the OVER SCAN is set to 10.
	Using the ◄/► cursor buttons adjusts the horizontal position.
	Right ó Left
	• Over-adjusting the horizontal position may cause noise to appear on
	the screen. If this occurs, please reset the horizontal position to the
H POSITION	default setting. Pressing the RESET button on the remote control when
	the H POSITION is selected will reset the H POSITION to the default
	setting.
	• When this function is performed on a video signal or s-video signal,
	the range of this adjustment depends on the OVER SCAN (above)
	setting. It is not possible to adjust when the OVER SCAN is set to 10.

(continued on next page) 29