1. PLAYING A DISC
1Open the main unit by separating the top and bottom cabinets at the open mark (refer to diagram 1).
2Place a disc gently on the tray with the label side up, make sure the disc is seated on the spindle by pressing down in the center (refer to diagram 2), then close the door (refer to diagram 3).
Diagram 1 | Diagram 2 | Diagram 3 |
3Slide the DVD player main unit’s POWER switch to the ON position, the DVD player starts to read the disc’s table of contents (this may take a few seconds). the DVD logo
NOTE 1: Load the disc with the label side facing up, when playing a
NOTE 2: “NO DISC” will show in the display if the disc is upside down or the disc is badly scratched or dirty, it will not play. Please clean it or change the disc before use. Also you can buy a disc polisher to try to repair the scratched disc.
4Some discs will start playing automatically, and others will display the disc contents menu on the screen. If the menu is shown, use the (
, 
, 
& 
) direction buttons on the remote to highlight your selection and press the OK button to confirm, otherwise you may press play.
5Press the VOLUME + or VOLUME – button to adjust the volume level.
6Press the SCREEN ON/OFF button on the remote control, then press the left 
and right 
direction buttons to adjust the brightness and the color of the LCD screen if needed. You can also press the BRIGHTNESS and COLOR buttons on the slave unit to adjust the slave unit’s LCD screen.
7To stop playback, press the STOP button 
.
8To pause the playback, press the OK button 
on the remote control or the PLAY/PAUSE button 
on the main unit. To resume playback, press the OK button 
on the remote control or the PLAY/PAUSE button 
on the player again.
NOTE 1: During play, pressing the STOP button once will show “PRE - STOP 
” in the
display, if you press the STOP button the second time, the display will show “
”, and now your system is in the full STOP mode.
NOTE 2: Leaving the set in the stop mode for a longer time will drain the battery the same as during normal play, remember to shut off the power after use.
9To skip to another track/chapter, press the SKIP/SEARCH 
or SKIP/SEARCH 
button repeatedly during playback.
10To access the disc menu or title menu during DVD play, press the MENU or TITLE button on the remote control.
11Remember to shut off the player by sliding both the main unit and the slave unit’s POWER
switches to the OFF position when the movie finishes playing. 16
2/12/2007, 1:19 AM
