TROUBLE SHOOTING
Symptom
No image on the main unit’s LCD screen.
No power.
No image on the slave unit’s LCD screen.
Slave unit cannot be adjusted.
Battery drains too fast in stop mode.
General | • Play fails to start even |
| |
| when PLAY is pressed. |
| • Play starts but then |
| stops immediately. |
No picture on your external TV’s screen.
The picture is distorted.
Some lines appear on the screen during the startup of the vehicle.
Remedy
The main unit’s LCD may be turned off.
1.Make sure the main unit’s DISPLAY ON/OFF switch is at the ON position.
2.Press and hold the SCREEN ON/OFF button on the remote or turn the player off and turn it on again.
1.The POWER switch is at the OFF position, please slide it to ON.
2.The
3.The fuse in the car adaptor is blown. To change the fuse, unscrew the tip, replace only with same 3A 250V fuse.
4.When you are using the main unit and the slave unit together, make sure the two units are connected as the steps on pages 9, 10 and 12.
1.Make sure the two units are connected correctly.
2.Make sure the POWER switch is at the ON position of both sets.
Only the main unit can be adjusted, the slave unit is just a second screen with speakers.
The set continues to be on even in stop mode. If you plan on leaving the disc stopped for a longer time, turn the set’s power off to conserve battery power or use the AC adaptor.
1.Make sure all power cables are connected properly.
2.The disc may be damaged or scratched.
3.This player cannot play a DVD disc other than region 1 standard.
4.The disc may be dirty and may require cleaning.
5.Ensure that the disc is installed with the label side up (facing you).
6.If your disc is rented, it may be scratched or damaged from a previous renter. Return it or polish it.
7.Condensation may have formed on your disc. Wait about 1 hour to allow the player to dry out.
1.Ensure that the equipment is connected properly. Double check all cables and AC power.
2.Select the proper video channel on your TV set, VIDEO 1, 2, 3, etc.
3.Check if the proper AV input is selected on your TV set video inputs (some TV sets have 3 or 4 different inputs).
4.Make sure both the TV and DVD player are on.
1.Picture is distorted during rapid advance or rapid reverse. The picture may be somewhat distorted occasionally, this is normal.
2.Did you connect your DVD player to your VCR? Please connect the player directly to your TV and disconnect the VCR. This player has Macrovision copy protection, this will distort pictures when used with VCRs.
Please turn the unit off and turn it on again after the vehicle is running.
28 |
2/12/2007, 1:20 AM
