2.5.1 Port-based QoS For Application based QoS, user can specify a destination port number and associate it with a egress
priority(High or Low). For example, if user config port 7297 with high priority, then user would experience
better service quality for such flows.
For Port based QoS, user can specify the High/Low queue priority for each Ethernet port and can apply total
rate limit to any port from 128Kbps to 32Mbps or at Full-rate(100Mbps). Flow control can also be
enabled/disabled on per-port basis.
Parameter Description
Enable QoS by
Application Enable application-based QoS.
Protocol/Specific Port# Set the priority of the specified protocol name or port number to higher or
lower priority.
Enable QoS by device
port Enable Port-based QoS.
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other
advance sections or start using the router (with the advance settings in place)