Transceiver Service | EFJohnson High Tier, LTR 98xx manual

MISCELLANEOUS

Transceiver Service

If your transceiver is not operating properly, “OUT-LOCK” or

“PROG ERR” may be displayed. To attempt to clear this condition, turn power off and then on again to reset the control logic. Another indication that could be displayed is “NO POWER”. This indicates that transmitter temperature or supply voltage may be excessive. Release the PTT switch and allow the transceiver to cool, and make sure that the vehicle battery voltage is within the normal range.

Also make sure that the controls are properly set and that the power, external speaker (if used), and accessory (if used), cables are securely plugged into the back of the transceiver. If the transceiver is completely inoperative, check the power cable fuse. If it is blown, remedy the cause if possible and replace it with the same type (15A). If the transceiver still does not operate properly, return it to your system operator for service.

NOTE: There are no user-serviceable components in the transceiver. Altering internal adjustments can cause illegal emissions, void the warranty, and result in improper operation that can seriously damage the transceiver.

55

Image 55

EFJohnson High Tier, LTR 98xx manual Transceiver Service

Contents

High Tier Operating Manual Page Page Safety Information Limits For General Population/Uncontrolled Exposure FCC Exposure Limits Frequency Whip Model No Base Model No Table of Contents Table of Contents Quick Reference Guide General Features Features Front Panel Controls Controls and Display Microphone Push-To-Talk PTT Switch Not Shown Push-button on Rear Panel Jacks and Connectors Display Description Determining Volume Level Power-Up SequenceGeneral Operation System/Group Display Information Numeric Display ModeAlpha Tag Display Mode Backlight Operation Select Mode Indication With Alpha Tag Display Select Mode Indication With Numeric DisplaySelecting the System and Group Setting Squelch Control LTR Operation Standard CallsIntroduction Placing a Standard Call Receiving a Standard Call Conventional Operation Placing Telephone Calls Telephone Calls Receiving a Telephone Call Landside-Originate Calls General FeaturesBank Select Emergency Switch Call IndicatorEncryption Function FCN Switch Encryption Indicator Horn Alert Home System/Group Select Option Select Power Turn-Off Delay Proceed Clear-To-Talk Tone Time-Out Timer Stealth ModeReceive-Only Groups Transmitter Thermal Foldback Option Switches and Menu ModeOption Switches Tone Select Switch Menu Mode and Option Switch Functions Using Menu Mode Menu Mode Introduction System and Group Scan System and Group Scan Scan List Programming Transmitting In The Scan Mode Scan Delay and Continue Timers System and Group Scan General LTR and Conventional Modes Monitoring Conventional Channels Before Transmitting Standard and Telephone Calls LTR FeaturesCalls on Priority and Block ID Codes Transmit Inhibit System Search Busy Queuing Transpond Monitor Mode Conventional FeaturesTransmit Disable On Busy Talk-Around Priority Group Sampling Call Guard Squelch Supervisory Tones Miscellaneous Miscellaneous LTR Telephone Call Tones Display Messages Miscellaneous Bright DIM OFF Menu Mode Messages Speaking Into Microphone System Operator Programming Operation At Extended Range Preventing Battery DischargeLicensing Transceiver Service