12
Installing Your Server Adapter
ENGLISH
Installing DIVA Server PRI
The DIVA Server PRI needs up to 20 Watts of power. If you have
several adapters installed in your system, make sure that the power
supply will not be overloaded when you install the DIVA Server PRI.
PRI signals can have telephone network voltages (TNV). Therefore,
PRI lines should be installed and maintained by service personnel only.
It may be hazardous if your computer is not properly plugged in and
grounded. This applies particularly to users in North America and
Australia.
To install the DIVA Server PRI:
Step One: Insert the adapter into your computer
1.
For your safety, turn off the power to your computer and all peripheral
devices.
2.
Drain static electricity from your body by touching the metal chassis (the
unpainted metal at the back of your computer).
3.
Remove the power cord from your computer.
4.
Remove the cover of the computer as described in your computer’s manual.
5.
DIVA Server PRI model
800-217-02
only:
The default jumper settings are
shown below. Verify that the two jumpers on your adapter use the default
settings:
6.
Firmly insert the adapter into a free PCI slot, allowing the retainer to slide
between the guides. Make sure that the adapter does not touch the CPU,
memory modules, or any other parts on the motherboard.
Note
If space does not permit the use of the retainer, simply remove it, and
then insert the card. The retainer is only an installation aid and does not
add functionality to the card.
To avoid damaging your hardware, insert the DIVA Server PRI
adapter only into a PCI slot. Inserting the adapter into any other
type of slot can damage your adapter, your computer, or both.
7.
Firmly secure the adapter with the screw (or clip), to ensure that the adapter
is properly grounded to the computer’s chassis.
8.
Replace the cover of the computer as described in your computer’s manual.
Retainer
DIVA Server PRI
Jumper
JP 701
JP 702