Eicon Networks Adapters - page 18

18 Installing the Software
ENGLISH
Step Three: Install Remote Access Service (RAS)
1. From the displayed message box, click “Yes” to install RAS (if it is not
already installed) and configure RAS.
Note If you install RAS, you also have to re-install Windows NT
Service Pack 3.
2. If RAS is not already installed on your system, the Eicon WAN-Miniport
Driver Setup dialog box appears. Insert your Windows NT CD-ROM or
Setup diskette into the appropriate drive and type D:\I386 (where D is
the drive that contains the Windows NT CD-ROM or Setup diskette). Click
“OK”.
3. If RAS is already installed on your system, the Remote Access Setup
dialog box appears. Click “Add”.
4. From the Add RAS Device dialog box, select “ISDN1-DIWAN” and click
“OK”. This adds the first port.
5. The Remote Access Setup dialog box appears as shown:
Select “ISDN1 DIWAN”, and click “Configure”.
6. From the Configure Port Usage dialog box, specify how you want to use
the port.
• “Receive calls only”: RAS server only receives calls from remote
clients.
• “Dial out and Receive calls”: RAS server receives calls from remote
clients, as well as dials out to other remote networks (for example, to
connect to an Internet Service Provider).
Click “OK”.
7. Click “Clone” as often as necessary to add a new port with the same config-
uration as the first port. For example, if you have a PRI line (30
B-channels) and a DIVA Server PRI adapter, you can clone the first port 29
times to add and configure ISDN2 DIWAN to ISDN30 DIWAN.