16 Installing the Software
ENGLISH
The Eicon Adapter Setup dialog box appears:
11. From “ISDN Protocol (Switch Type)”, select the switch type specified by
your ISDN service provider.
In general, if you are in Europe, select “Europe and other countries,
Euro-ISDN (E-DSS1)” (commonly referred to as ETSI standard).
12. If the hardware resources fields are not grayed out: Ensure that the default
hardware resources (“Interrupt Number” and “I/O Port Base Address”) are
not used by other devices in your computer. If necessary, change the default
values.
Note For the DIVA Server BRI-2M, you can use the following interrupts:
3, 4, 5, 7, 9, 10, 11, 12, 14, and 15.
To determine which hardware resources are used by other devices, click
“Launch Windows NT Diagnostics” and select the “Resources” tab:
• To view which interrupts are used by other devices, click “IRQ”.
• To view which I/O port base addresses are used by other devices, click
“I/O Port”.
• To return to the Eicon Adapter Setup dialog box, click “OK”.
13. From “ISDN Interface Type”, select the type of interface to which the
Server adapter is connected.
• “Standard”: The Server adapter is operated on a standard ISDN bus.
This option is available only if you are using a DIVA Server BRI-2M
adapter.
• “Point to Point”: The Server adapter is operated on a point to point (or
direct dialing) NT2 interface.
• “Leased Line”: The Server adapter is operated on a group 2 leased line.
Typically, BRI adapters use the Standard interface, and PRI adapters use the
Point to Point interface.