22 Installing the Software
ENGLISH
To install DIVA for Windows NT featuring SBS on a new server:Before you begin the installation, make sure that your system meets the
requirements for installing Microsoft SBS (see the Microsoft SBS
documentation). Also, you must install DIVA for Windows NT featuring SBS
from CD-ROM (not from diskettes or from your hard-disk drive).
Step One: Re-create the SBS boot floppies
Important For the installation to work properly, you need to install SBS using the
modified boot floppies you create in this step. These modified boot floppies
replace the setup boot floppies you received with Microsoft Small Business Server.
The boot floppies can be created on any computer running Windows or DOS.
1. Make sure you have three blank, formatted, floppy diskettes to create the
SBS boot floppies. You will create the following disks:
• Windows NT Server Setup Boot Disk
• Windows NT Server Setup Disk 2
• Windows NT Server Setup Disk 3
2. Insert the ISDN Software Suite CD-ROM into your CD-ROM drive.
3. At the command prompt, type D:\SBS\DIVASBS.EXE (where D is your
CD-ROM drive letter), and press Enter.
4. When prompted, insert the required Microsoft SBS CD-ROM into the
appropriate drive.
5. Follow the on-screen instructions to create the boot floppies.
6. After you create the boot floppies, you are prompted to insert the
Windows NT Server Setup Boot Disk and then the Windows NT Server
Setup Disk 2 you created. This updates the SBS setup boot floppies to
include DIVA for Windows NT featuring SBS.
Note You should use these new boot floppies only on a system that has a DIVA
Server BRI-2M adapter.
Step Two: Install Microsoft SBS and DIVA for Windows NT featuring SBS
1. Insert the Windows NT Server Setup Boot Disk you created into a floppy
drive.
2. Reboot your computer.
3. Follow the on-screen instructions.
Note You do not have to connect a modem to your server (even though this
is recommended in the Microsoft SBS Installation Guide); the SBS installa-
tion program detects your adapter as a modem.