Observe the following safeguards when setting up your projector.
Caution concerning the lamp unit
■Potential hazard of glass par-
ticles if lamp ruptures. In case of lamp rupture, contact your nearest EIKI Authorized Dealer or Service Center for replacement.
See “Replacing the Lamp” on page 55.
Caution concerning the setup of the pro- jector
■For minimal servicing and to maintain high image quality, EIKI recommends that this pro- jector be installed in an area free from hu- midity, dust and cigarette smoke. When the projector is subjected to these environments, the vents and lens must be cleaned more of- ten. As long as the projector is regularly cleaned, use in these environments will not reduce the overall operation life of the unit. Internal cleaning should only be performed by an EIKI Authorized Dealer or Service Cen- ter.
When using the projector in
■When you use the projector in
Warning about placing the projector in a high position
■When placing the projector in a high position, ensure that it is secured carefully to avoid per- sonal injury caused by the projector falling down.
Do not subject the projector to hard im- pact and/or vibration.
■Protect the lens so as not to hit or damage the surface of the lens.
Rest your eyes occasionally.
■Continuously watching the screen for long hours will cause eye strain. Be sure to occa- sionally rest your eyes.
Do not set up the projector in places ex- posed to direct sunlight or bright light.
■Position the screen so that it is not in direct sunlight or room light. Light falling directly on the screen washes out the colors, making viewing difficult. Close the curtains and dim the lights when setting up the screen in a sunny or bright room.
Caution regarding placing of the projec- tor
■Place the projector on a level site within the adjustment range (8 degrees) of the adjust- ment foot.
■After the projector is purchased, a faint smell from the vent may appear when the power is first turned on. This is normal and is not a malfunction. It will disappear after the projec- tor is used for a while.
Avoid locations with extremes of tem- perature.
■The operating temperature of the projector is from 41°F to 95°F (+5°C to +35°C).
■The storage temperature of the projector is from
Do not block the exhaust and intake vents.
■Allow at least 11 13/16 inches (30 cm) of space between the exhaust vent and the nearest wall or obstruction.
■Be sure that the intake vent and the exhaust vent are not obstructed.
■If the cooling fan becomes obstructed, a pro- tection circuit will automatically put the pro- jector into standby mode to prevent overheat damage. This does not indicate a malfunc- tion. (See pages 53 and 54.) Remove the pro- jector power cord from the wall outlet and wait at least 10 minutes. Place the projector where the intake and exhaust vents are not blocked, plug the power cord back in and turn on the projector. This will return the projector to the normal operating condition.
8