Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS- 232C adaptor and an RS-232C serial control cable (cross type, commercially available), the com- puter can be used to control the projector and check the status of the projector. Refer to the “SETUP MANUAL” contained on the supplied CD-ROM for details.

When connecting to a computer using an RS-232C serial control cable and a DIN- D-sub RS-232C adaptor

Supplied accessory

DIN-D-sub

To RS-232C terminal

 

RS-232C

 

adaptor

 

Computer

To RS-232C terminal

DIN-D-sub RS-232C adaptor

RS-232C serial control cable (cross type, commercially available)

Note

The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the owner’s manual of the computer for details.

Refer to page 3 of the “SETUP MANUAL” contained on the supplied CD-ROM for “RS-232C Speci- fications and Commands”.

Info

Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may damage your computer or projector.

Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your computer.

26

Page 30
Image 30
Eiki EIP-3000N owner manual Controlling the Projector by a Computer, To RS-232C terminal