Eiki LC-XB27 owner manual Input Source Selection Rgbpc digital, Rgbav Hdcp

Computer Input

Input Source Selection (RGB(PC digital), RGB(AV HDCP))

Direct Operation

Choose Computer 1(Digital) by pressing the INPUT button on the top control or press the COMPUTER button on the remote control.

Before using these buttons, correct input source should be selected through Menu operation as described below.

Top Control

	POWER	WARNING LA
	MENU	INPUT	AU
ON
-
OFF
	SELECT

INPUT button

INPUT button

Computer 1

(Analog/Digital)

Computer 2 ✳

Menu Operation

1 Press the MENU button to display the On-Screen Menu. Press the Point 7 8 buttons to move the red framed pointer to the Input Menu icon.

2 Press the Point ed buttons to move the red arrow pointer to Computer 1(Digital), and then press the SELECT button.

3 After the Source Select Menu appeared for Computer 1(Digital), move the pointer to RGB (PC digital) or RGB (AV HDCP) and then press the SELECT button.

✔Note:

•Computer 2 is not displayed when the COMPUTER IN 2 / COMPONENT IN / MONITOR OUT terminal is set as Monitor out. (p50)

•Computer 2 (COMPUTER IN 2 / COMPONENT IN / MONITOR OUT) can accept only RGB signal.

•HDCP (High-bandwidth Digital Content Protection) is a system for protecting digital entertainment content delivered by DVI (Digital Visual Interface) from being copied. The specification of HDCP is decided and controlled by Digital Content protection, LLC. Should the specification be changed, this Projector may not display the digital content protected by HDCP.

•Wired, Wireless, and Memory Viewer are for the Network function. Refer to the owner's manual "Network Set-up and Operation"

supplied with this projector or the owner's manual of Memory viewer (optionally available).

Video

Wired

Remote Control

COMPUTER button

COMPUTER button

Computer 1

(Analog/Digital)

Computer 2 ✳

✳See Note at the bottom of this page.

Input Menu icon

Input Menu

Move the pointer (red arrow) to Computer 1 (Digital) and press the SELECT button.

Computer

1

Move the pointer to the source that you want to select and press the SELECT button.

30