Eiki LC-XB27 owner manual Lamp Replacement Counter, When the Lamp replacement

Maintenance and Cleaning

Lamp Replacement Counter

Be sure to reset the Lamp replacement counter after the lamp is replaced. counter is reset, the LAMP REPLACE indicator stops lighting.

1	Turn the projector on, press the MENU button to
	display the On-Screen Menu. Press the Point 7 8
	buttons to move the red framed pointer to the Setting
	Menu icon.
2	Press the Point ed buttons to move the red framed
	pointer to the Lamp counter function and then press
	the SELECT button. The first dialog box appears and
	shows the total accumulated time of the lamp usage
	and the reset option. If you select "Reset", a "Lamp
	replacement counter Reset?" message will appear.
	Select [Yes] to continue.
3	Another confirmation dialog box will appear, select
	[Yes] to reset the Lamp replacement counter.

✔Note:

Do not reset the Lamp replacement counter without implementation of lamp replacement. Be sure to reset the Lamp replacement counter only after replacing the lamp.

When the Lamp replacement

To reset the lamp counter, move the pointer to Reset and then press the SELECT button.

“Lamp replacement counter Reset?” dialog box will be displayed.

Select [Yes], then another confirmation box will appear.

Select [Yes] again

to reset the lamp counter.

Maintenance & Cleaning

LAMP HANDLING PRECAUTIONS

This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling may result in accidents, injury, or create a fire hazard.

●Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time than other similar lamps.

●If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.

( Follow carefully the instructions in the Lamp Replacement section of this manual. ) Continuous use of the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.

●A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.

59