Eiki LC-XD25 owner manual Remote control

Setting

Lamp control

This function allows you to change brightness of the screen.

Normal . .	normal brightness
Auto . . .	brightness according with the input
	signal
Eco	lower brightness reduces the lamp
	power consumption and extends the
	lamp life.

✔Note:

Lamp mode cannot be changed for a while after turning on the projector. Lamp needs some time to stabilize after the power is turned on. Stored lamp mode will be active after the lamp is stabilized.

Remote control Remote control

This projector provides two different remote control codes: the factory-set initial code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

When operating the projector in "Code 2", both the projector and the remote control must be switched to "Code 2".

To change the code for the projector:

Select either "Code 1" or "Code 2" in this Setting Menu.

To change the code for the remote control:

Press and hold both the MENU and IMAGE buttons together for 5 seconds or more. After changing the code, make sure the remote control operates properly.

✔Note:

If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.

P r e s s a n d h o l d MENU and IMAGE buttons for more than 5 seconds.

52