Appendix
Indicators and Projector Condition
Check the indicators for projector condition.
| Indicators |
|
|
|
|
| Projector Condition |
POWER | WARNING | LAMP | |
REPLACE |
| ||
red/green | red | yellow |
|
|
|
| |
|
|
| The projector is off. (The AC power cord is unplugged.) |
|
|
|
|
|
|
| The projector is preparing for |
✽being cooled down. The projector cannot be turned on until cooling is completed.
The projector is ready to be turned on with the POWER ON/STAND-
✽BY button.
✽ | The projector is operating normally. | |
|
| |
|
| |
✽ | The projector is in the Power management mode. | |
|
| |
|
| |
| The temperature inside the projector is abnormally high. The | |
| projector cannot be turned on. When the projector is cooled | |
✽ | down enough and the temperature returns to normal, the POWER | |
| indicator lights red and the projector can be turned on. (The | |
| WARNING indicator keeps blinking.) | |
|
| |
| The projector has been cooled down enough and the temperature | |
✽ | returns to normal. When turning on the projector, the WARNING | |
| indicator stops blinking. Check and clean the air filter. | |
|
| |
| The projector detects an abnormal condition and cannot be turned | |
| on. Unplug the AC power cord and plug it again to turn on the | |
✽ | projector. If the projector is turned off again, disconnect the AC | |
power cord and contact the dealer or the service center for service | ||
| and checkup. Do not leave the projector on. It may cause an electric | |
| shock or a fire hazard. |
|
|
|
|
• • • green | • • • red | • • • off |
• • • blinks green | • • • blinks red |
|
✽When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp replacement counter after replacing the lamp. See pages
69
