Eiki LC-XD25 owner manual Input Source Selection S-video, Component, RGB Scart 21-pin, Video Input

Video Input

Input Source Selection (S-video, Component, RGB Scart 21-pin)

Direct Operation

Choose S-video, Component or RGB(Scart) by pressing the COMPUTER button on the remote control.

Before using COMPUTER button, correct input source should be selected through Menu operation as described below.

Remote Control

COMPUTER button

COMPUTER button

✔Note:

The operations in the figure are processed when the Input Search function is set to "Off".

S-video

✳Computer 2 RGB(Scart)

✳Computer 2

✳

Component

Computer 2

✳See Notes at the bottom of this page.

Menu Operation

1	Press the MENU button to display the On-Screen
	Menu. Press the Point 7 8 buttons to move the red
	framed pointer to the Input Menu icon.
2	Press the Point ed buttons to move the red arrow
	pointer to Computer 1 and then press the SELECT
	button.
3	After the Source Select Menu appeared for Computer
	1, move the pointer to S-video, Component or RGB

(Scart) and then press the SELECT button.

Input Menu Input Menu icon

Move the pointer (red arrow) to Computer 1 and press the SELECT button.

Computer

1

Source Select Menu

S-video

Component

RGB (Scart)

When S-video input signal is connected to the COMPUTER IN 1/S-VIDEO IN/ COMPONENT IN jack with a S-VIDEO- VGA cable, select S-video.

W h e n t h e i n p u t s o u r c e i s c o m i n g f r o m v i d e o e q u i p m e n t c o n n e c t e d t o t h e C O M P U T E R I N 1 / S - V I D E O I N / C O M P O N E N T I N t e r m i n a l w i t h a C o m p o n e n t - VG A C a b l e , s e l e c t Component.

W h e n t h e i n p u t s o u r c e i s c o m i n g from video equipment connected to the COMPUTER IN 1/S - VIDEO IN/ COMPONENT IN terminal with a Scart- VGA Cable, select RGB (Scart).

M o v e t h e p o i n t e r t o

S-video, Component or

RGB (Scart) and press the

SELECT button.

✔Notes:

•When the COMPUTER button is pressed while the Input search function is set to "On1" or "On2", the input signal will be searched automatically (p.46)

•When Monitor out is selected in the Terminal function (p.50), Computer 2 is not displayed.

38