Eizo S1932 manual Preset Timing, Frequency Mode Dot clock, Polarity, Vertical Hz

5-6 Preset Timing

The following table shows factory preset video timing (for analog signal only).

			Frequency
Mode	Dot clock		Horizontal: kHz	Polarity
			Vertical: Hz
VGA 640×480@60Hz	25.2 MHz	Horizontal	31.47	Negative
		Vertical	59.94	Negative
VGA 720×400@70Hz	28.3 MHz	Horizontal	31.47	Negative
		Vertical	70.09	Positive
Macintosh	30.2 MHz	Horizontal	35.00	Negative
640×480@67Hz		Vertical	66.67	Negative
Macintosh	57.3 MHz	Horizontal	49.72	Negative
832×624@75Hz		Vertical	74.55	Negative
Macintosh	100.0 MHz	Horizontal	68.68	Negative
1152×870@75Hz		Vertical	75.06	Negative
Macintosh	126.2 MHz	Horizontal	74.76	Positive
1280×960@75Hz		Vertical	74.76	Positive
VESA 640×480@72Hz	31.5 MHz	Horizontal	37.86	Negative
		Vertical	72.81	Negative
VESA 640×480@75Hz	31.5 MHz	Horizontal	37.50	Negative
		Vertical	75.00	Negative
VESA 800×600@56Hz	36.0 MHz	Horizontal	35.16	Positive
		Vertical	56.25	Positive
VESA 800×600@60Hz	40.0 MHz	Horizontal	37.88	Positive
		Vertical	60.32	Positive
VESA 800×600@72Hz	50.0 MHz	Horizontal	48.08	Positive
		Vertical	72.19	Positive
VESA 800×600@75Hz	49.5 MHz	Horizontal	46.88	Positive
		Vertical	75.00	Positive
VESA 1024×768@60Hz	65.0 MHz	Horizontal	48.36	Negative
		Vertical	60.00	Negative
VESA 1024×768@70Hz	75.0 MHz	Horizontal	56.48	Negative
		Vertical	70.07	Negative
VESA 1024×768@75Hz	78.8 MHz	Horizontal	60.02	Positive
		Vertical	75.03	Positive
VESA 1152×864@75Hz	108.0 MHz	Horizontal	67.50	Positive
		Vertical	75.00	Positive
VESA 1280×960@60Hz	108.0 MHz	Horizontal	60.00	Positive
		Vertical	60.00	Positive
VESA 1280×1024@60Hz	108.0 MHz	Horizontal	63.98	Positive
		Vertical	60.02	Positive
VESA 1280×1024@75Hz	135.0 MHz	Horizontal	79.98	Positive
		Vertical	75.03	Positive
PC-9801 640×400@56Hz	21.1 MHz	Horizontal	24.83	Negative
		Vertical	56.42	Negative
PC-9821 AP2	25.2 MHz	Horizontal	31.48	Negative
640×400@70Hz		Vertical	70.10	Negative

Attention

•Display position may be deviated depending on the PC connected, which may require screen adjustment using Adjustment menu.

•If a signal other than those listed in the table is input, adjust the screen using the Adjustment menu. However, screen display may still be incorrect even after the adjustment.

•When interlace signals are used, the screen cannot be displayed correctly even after screen adjustment using the Adjustment menu.

Chapter 5 Reference 35