E L A N H O M E S Y S T E M S | USER GUIDE |
CONFIGURING YOUR REMOTE TO CONTROL OTHER DEVICES
The TV and Amp devices on the VIA!dj remote control may be individually configured to control a range of televisions and amplifiers from well known manufacturers.
To configure the remote to control your television:
•Press the TV and 
buttons simultaneously; hold them down for 1 second.
The TV button will remain lit for 20 seconds; the configu- ration process must be completed during this time.
•Enter the 3 digit numeric code matching the manufacturer of your television from the list in Appendix A, p.
•Press the TV button again.
The TV button will blink twice to indicate that the configuration has been accepted. If the TV button does not blink begin the process again, taking care to enter the number exactly as print- ed in the list. If the television is switched on during the config- uration process, entering the correct code will cause the televi- sion to go into standby.
To configure the remote to control your amplifier:
•Press the Amp and 
buttons simultaneously; hold them down for 1 second.
The Amp button will remain lit for 20 seconds; the configuration process must be completed during this time.
•Enter the 3 digit numeric code matching the manufacturer of your amplifier from the list in Appendix A.
•Press the Amp button again.
The Amp button will blink twice to indicate that the configura- tion has been accepted. If the Amp button does not blink begin the process again, taking care to enter the number exactly as printed in the list. If the amplifier is switched on during the configuration process, entering the correct code will cause the amplifier to go into standby.
SWITCHING ON AND OFF
The VIA!dj was designed to remain on 24/7/365. If the VIA!dj is not going to be used for an extended period of time and you wish to turn it off, there are two power saving modes available from the Standby button on the VIA!dj front panel and the 
button on the remote control. The VIA! Touch Panel can be used to take the VIA!dj out of Standby, but it cannot be used to put the VIA!dj into Standby Mode.
STANDBY AND OFF MODES
Standby Mode
Putting the unit into standby takes just a few seconds; switch- ing the unit on from standby also takes just a few seconds. DO NOT remove the power cord from the VIA!dj in this mode.
Off Mode
Off mode should be used only if the VIA!dj is not being used for an extended period of time. There is a short wait while the unit is switched to off mode; switching the unit on from off mode may take a few minutes. You can safely remove the power from the VIA!dj in this mode.
To enter standby or off mode:
•Press the Standby key on the front panel or the 
Standby key on the remote control.
The following screen is displayed:
The front panel display shows:
Either: |
•Press the Standby button on any VIA! Touch Panel, or the Stby action key on the front panel, or the 
key on the remote control to switch to standby.
After a short delay the screen shows:
Or:
•Press the Off button on any VIA! Touch Panel, or the Off action key on the front panel, or the 
key on the remote control to switch to off mode.
After a short period of time the display and front panel display will switch off.
To switch on from standby or off mode:
•Press the Standby button on any VIA! Touch Panel, or press the Standby key on the front panel, or the 
Standby key on the remote control.
© ELAN Home Systems 2004 • All rights reserved. 02/04 | Page 11 |
