E L A N H O M E S Y S T E M S | USER GUIDE |
TERMS AND CONDITIONS
Displays the terms and conditions of the XIVA Customer Service Agreement.
• Press ✔Cont. to return to the Settings menu.
DEFAULT RECORDING QUALITY
Allows you to specify the recording quality used when you record music using the Auto record option:
For each quality setting the screen shows the number of hours of recording time available at that setting.
OPTION
Internet Access
Modem Settings
Ethernet Settings
Controller Settings
Video Settings
Remote Diagnostics
DESCRIPTION
Specifies whether your VIA!dj connects to the Internet via the
Allows you to specify the following settings when connecting via the
Allows you to specify the following settings when connecting via the Ethernet port: IP address mode, IP address, IP Mask, Gateway, IP DNS1, IP DNS2.
Specifies the communication speed for the Controller port on the rear of the unit.
Specifies whether the unit is config- ured for NTSC or PAL use.
Select this option if instructed to set up your modem to receive incoming calls from ELAN technical support
staff.
LANGUAGE
Allows you to select the language for the TV user interface— languages available are English, French, German, Italian, and Spanish.
SYSTEM INFORMATION
Shows the serial number, production date, and software version number of your VIA!dj. You may need to quote these if you contact ELAN for technical support.
SYSTEM SETTINGS
Provides a series of menus to allow you to change the hardware configuration on your VIA!dj:
The table in the next column summarizes the settings available on each of the System Settings menus:
DEDICATED REMOTE CONTROL USE IN A MULTIROOM SYSTEM
In rooms that have TVs with VIA!dj graphics available, but do not have VIA! Touch Panels, you may wish to have a dedicated VIA!dj remote control for that specific room. Your VIA!dj remote control can be configured so that every button press indicates to the VIA!dj which output is to be controlled. This means that whenever
To configure the remote with a default output
•Press the HDD Audio and 
k buttons simultaneously; hold them down for 1 second.
The HDD Audio button will remain lit for 20 seconds; the configuration process must be completed during this time.
•Enter the 3 digit code corresponding the output you would like to control (valid configurations are listed in Appendix A). For example, to set output 2 as your default output press: 0, 0, 2
•Press the HDD Audio button again.
The HDD Audio button will blink twice to indicate that the configuration has been accepted. If the HDD Audio button does not blink twice begin the process again, taking care to enter the number correctly.
If the VIA!dj is switched on during the configuration process the Enter Standby? prompt will appear once configuration is complete. Press ✖Cancel to return to the previous screen.
Now, pressing any navigation key on the remote should cause the VIA!dj to switch to the correct output. To return the remote control to factory default Output select operation:
•Follow the above procedure and enter 0, 0, 0 as the
© ELAN Home Systems 2004 • All rights reserved. 02/04 | Page 25 |
