Design Spot 575B™
functions may result reduced performance or damage to the fixture.
Service Password: The correct password must be entered before attempting wheel calibration, changing fan voltage, or changing the gobo speed.
Fan Voltage: This function will change the fan voltage from either “Low” or “High.” Low will send normal voltage to the fan, for normal operation. High will send slightly higher voltage to fans that allows the fans to operate at higher than normal speeds. This setting should only be used in extreme cases of higher than normal temperatures. Using the fans in “HIGH” mode will decrease fan life over time. Low is the default setting.
Gobo Speed: This function will change the speed at which the gobo wheel moves. This function allows Design Spot 575Bs and Design Spot 250s to be implemented together in the same rig. There are two different settings, “Quick” and “Slow.” Slow will move the gobo wheel at a speed that matches the first generation Design Spot
250. The “Quick” setting will advance the wheel at a new, faster rate than the original Design Spot 250. “Quick” is the default setting.
9.4.3.Fans Control - This function is used to change the functionality of the internal cooling fans. The available selections are: 1) “AUTO” – The fans will automatically switch between low and high speeds depending on the internal operating temperature. 2) “HIGH” – The fans will run in
9.4.4.Temperature C/F – This function changes the temperature unit readout from either the temperature Celsius or Fahrenheit.
9.4.5.Initial effect - With this function, you can adjust with which value the respective channels will start.
9.4.6.Restore Default - With this function you can restore the factory settings of the device. All settings will be set back to the default values (shaded). Any edited
©Elation Professional, Los Angeles CA. | 29 | Design Spot 575B™ |
