Using the automatic warm-up function

Switching on the automatic warm-up function

The duration of the warm-up phase depends on the heat setting selected.

Set the required heat setting ( to ) via the “heat setting selection” sensor field . The set power level lights up in the digital display.

lights up in the digital display after approx. five seconds. The automatic warm-up function is activated.

In the event of residual heat being present the automatic warm-up function will not be activated for this cooking zone.

After the end of the warm-up time, the heat setting selected will be shown again.

When the automatic warm-up function is active select a higher heat setting, e.g. instead of , the warm-up time will be automatically adjusted to the selected heat setting.

If you select a lower heat setting the automatic warm-up function will be switched off immediately.

Switching off the automatic warm-up function

Only an activated automatic warm-up function may be switched off. Touch the „heat setting selection“ sensor field.

The heat setting selected lights up in the digital display.

The automatic warm-up function is switched off.

Do not use the automatic warm-up function

18