INSTALLATION INSTRUCTIONS
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is GREEN and YELLOW must be connected to the terminal in the plug which is marked with the letter 'E' or by the earth symbol 
or coloured GREEN or GREEN and
YELLOW.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter 'N' or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter 'L' or coloured RED.
FIT A 3 AMP FUSE TO THE PLUG FUSE HOLDER
Turn on Gas and Electric supplies
Carry out a soundness test.
Switch off electric supply.
INSTALLATION BETWEEN
CABINETS
Lift the appliance into the cabinet making sure the hose and cable are not trapped. Push the appliance as far back as it will go.
N.B. Two people will be required to carry out the lifting procedure.
Warning: Do not attempt to lift this appliance by the handle(s).
Centralise and fix the appliance to the underside of the worktop using the two stability screws provided, in the position indicated in Fig.10.
Refit the plinth board.
Place the top trim with the cork washers uppermost flush with the edge of the worksurface (see Fig.11) and screw into position using the screws supplied with the appliance.
Switch on the appliance then refer to the operating instructions in the following pages.
Carry out gas soundness check.
Ensure the owner is given these operating instructions.
CHECKING ELECTRICAL
CONNECTIONS
Confirm the appliance is correctly connected by switching on and observing the various oven functions .
The electronic timer will flash on and off.
NOTE: HOUSE CIRCUIT
Earth leakage / continuity tests must be carried out before the appliance is connected to the mains supply and
Fig.10
Fig.11
39
