INSTALLATION
INSTALLING THE APPLIANCE
1.Remove all packaging and check carefully for any signs of damage.
2.If fitting the microwave oven above a conventional oven (position A) then use the mylar sheet provided.
a.Cut the Mylar sheet to fit the internal width of the unit.
b.Peel back the protective cover on the tape and fix to the rear of
the shelf so that it covers the service gap. (See
diagram).
Internal | width | |
| ||
Conventional | gap | |
Service | ||
oven | ||
|
3.Fit the appliance into the kitchen cupboard slowly, and without force, until the front frame of the oven seals against the front opening of the cupboard.
4.Ensure the appliance is
stable and not leaning. |
|
Ensure that a 5 mm gap | 5 mm |
is kept between the |
|
cupboard door above |
|
and the top of the frame |
|
(see diagram). |
|
5. Fix the oven in position with the screws provided.
The fixing points are located on the top and bottom corners of the oven (see diagram, item 10, on page 5).
6.It is important to ensure that the installation of this product conforms to the instructions in this operation manual and the conventional oven manufacturer’s installation instructions.
The microwave can be fitted in position A or B:
Chimney
Chimney
Position A | Position B |
Conventional
oven
POSITION | NICHE SIZE | CHIMNEY | Gap Between |
| W D H | (min) | Cupboard & Ceiling |
A | 560x550x450 | 50 | 50 |
B | 560x500x450 | 40 | 50 |
|
|
|
|
Measurements in (mm)
NOTE: Ensure the bottom of the oven is 85 cm or more above the floor.
40
