S G 4 2 4
If the ignition system doesn't work there may be a fault with the electrical supply. First, check the socket by trying out another piece of electrical equipment in it, if that works correctly renew the fuse in the plug.
If the fuse keeps failing there is a fault in the appliance which must be put right. Do not use a fuse with a rating higher than 3 amps. Do not carry out other electrical work. Unplug the appliance and tell your installer.
For your safety
Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection, as described in the installation instructions. If this is the case contact the person who installed the appliance.
Replacing the oven light bulb
You need a 25 Watt small Edison screw with a temperature rating of T300.
Make sure the oven is cool before you replace a bulb. Unplug the appliance.
Open the oven door and remove the oven shelves.
Place palm of hand at top of lens f at against oven side. Use fingers to ever lens away from housing.
Unscrew the bulb by turning it to the left.
Fit a new bulb and then replace the glass bulb cover.
lReplace the oven shelves.
Plug the appliance back into the
electricity supply.
The oven light bulb is not covered by the manufacturer's guarantee.
General information
35