Elmira Stove Works 1954 manual Oven Conversion Model, To Convert Oven Bake and Broil Burner

A. PLASTIC COVER

B. GAS PRESSURE REGULATOR CAP WITH SOLID END FACING OUT

C. GAS PRESSURE REGULATOR CAP WITH HOLLOW END FACING OUT

D.WASHER

E.GAS PRESSURE REGULATOR CAP

Conversion of Regulator to “LP” on Model 1956 (gas oven)

•Remove storage drawer. See page 17.

•Locate the regulator at the rear of storage drawer compartment.

•Remove the plastic cover from the regulator cap.

•With your fingers, turn the nut counter clockwise.

•Do not remove the spring beneath the cap.

•Turn the cap over so LP faces up and reinstall into regulator.

•Replace plastic cover over regulator cap.

OVEN CONVERSION MODEL 1956

To Convert Oven Bake and Broil Burner

1.Remove oven racks.

2.use a 1/2" combination wrench to loosing the orifice hood away from the pin (about 2 to 2-1/2 turns). The oven bake burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Bake Burner Flame” section.

A. ORIFICE HOOD

B.PIN

C.NATURAL GAS: INCREASE GAS – INCREASE FLAME SIZE (PRESET AT FACTORY FOR NATURAL GAS)

D.LP GAS: DECREASE GAS, DEGREASE FLAME SIZE.

To Convert Oven Broiler Burner

1.Use a 1/2" combination wrench to loosen the orifice hood away from the pin (about 2 to 2-1/2 turns. The oven broil burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Broil Burner Flame” section.

2.Reinstall the storage or warming drawer.

3.Complete installation. See “Make Gas Connection” and “Electronic Ignition System” sections.

Checking for proper cooktop burner and oven bake burner flame is very important. Natural gas flames do not have yellow tips.

IMPORTANT: You may have to adjust “LO” setting for each cooktop burner.

13