ELSA manual Setup/Cable-module, Setup/LAN-module, Description of the menu options R89

Description of the menu options R89

/Setup	System configuration
IP-router-module	IP router module settings
SNMP-module	Settings for configuration via SNMP
DHCP-server-module	DHCP server settings
Config-module	Configuration module settings

Name	Here you can enter the device name (maximum 16 characters). The set of characters
	available includes uppercase and lowercase letters as well as some special characters.
	You can display the full range of available characters during a configuration session by
	entering the following command:

set \setup\name ?

In the default configuration, no name is entered.

Setup/Cable-module

This menu groups together all the settings necessary for starting up the interface to the cable network and for the connection to the headend.

These settings should only be changed by the cable network operator, as operation within the cable network will be impossible otherwise. The relevant menu items are therefore not covered in this documentation.

Setup/LAN-module

This menu item displays the connection values relevant for the local network. The menu has the following layout:

/LAN-module	LAN settings
Connector	Network connection
Node-ID	MAC layer address of the device

This option allows you to display the router’s own Ethernet address. The value displayed here was set at the factory and cannot be changed. The Ethernet address is displayed as a 12-digit hexadecimal value, with the first six digits '00a057' standing for an ELSA device.

ELSA MicroLink Cable