Quick Installation Guide

Rosemount 8712 / 8700 Series

00825-0100-4664, Rev BB January 2013

STEP 6 CONTINUED...

Connect the 4–20 mA Analog Signal

Cabling considerations

If possible, use individually shielded twisted pair cable, either in single pair or multi-pair varieties. Unshielded cables may be used for short distances, provided ambient noise and cross-talk will not adversely impact communication. The minimum conductor size is 0.51 mm diameter (#24 AWG) for cable runs less than 1,500 meters (@ 5,000 ft.) and 0.81 mm diameter (#20 AWG) for longer distances. Resistance in the loop must be 1000 ohms or less.

The 4–20 mA analog output loop signal may be powered internally or externally. The default position of the internal/external analog power switch is in the internal position. The user-selectable power supply switch is located on the electronics board.

8712E - connect negative (-)DC to Terminal 8 and positive (+)DC to Terminal 7. See Figure 18.

Figure 18. 8712E Analog Signal Wiring Diagram

+4–20 mA

–4–20 mA

Internal Power Source

The 4–20 mA analog signal loop is powered from the transmitter itself.

External Power Source

The 4–20 mA analog signal loop is powered from an external power source. HART multidrop installations require a 10–30 V DC external analog power source.

NOTE:

If a HART Field Communicator or control system will be used, it must be connected across a minimum of 250 ohms resistance in the loop.

To connect any of the other output options (pulse output and/or digital input/output), consult the comprehensive product manual.

22

Page 22
Image 22
Emerson 8712E manual Connect the 4-20 mA Analog Signal, Cabling considerations, +4-20 mA, Internal Power Source