Emerson PN-51-T56 0 Programming - Turbidity, Programming Measurements - Introduction

Instruction Manual	Clarity II T56
PN-51-T56	May 2012

Section 6.0 Programming - Turbidity

6.1Programming Measurements – Introduction

The T56 automatically recognizes each installed measurement board upon first power-up and each time the analyzer is powered. Completion of Quick Start screens upon first power

up enable measurements, but additional steps may be required to program the analyzer for the desired measurement application.

6.2Turbidity Measurement Programming

This section describes how to configure the T56 analyzer for Turbidity measurements. The following programming and configuration functions are covered.

1.Measurement type: Turbidity Select Turbidity or TSS calculation (estimated TSS)

2.Sensor type: Select EPA or ISO

3.Measurement units: NTU, FTU, FNU

4.Filter: 20 sec Override the default input filter, enter 0-999 seconds

5.Bubble Rejection: On Intelligent software algorithm to eliminate erroneous readings caused by bubble accumulation in the sample

1.To program the Measurement type, Select Turbidity or TSS calculation (estimated TSS)

and press ENTER/MENU.

2.To program the Sensor type: Select EPA or ISO and press

ENTER/MENU.

3.To program Measurement units: NTU, FTU, FNU and press ENTER/MENU.

4.To Override the default input filter,

enter 0-999 seconds and press ENTER/MENU.

5.To program Bubble Rejection, select On or Off and press ENTER/MENU.

Programming Measurements 23