S2HB Electrical Wiring Installation Section
! DANGER !
The EMI America Series condensing unit must:
•Be connected to a properly grounded electrical supply with the proper voltage as stated on the rating plate.
•Have proper over current protection (i.e. time- delay
Failure to follow these instructions can re- sult in a fiire, explosion, or electrical shock causing property damage, personal injury, or death.
! DANGER !
Do not use the EMI America Series condensing unit with any electrical supply voltage other than the one listed on the rating plate.
Check the rating plate on the unit for the correct voltage rating. Failure to use the correct voltage may result in death, serious bodily injury or property damage. If you have any questions or doubts, consult the factory before installing this unit.
1.All electrical wiring must be run according to NEC and local codes.
2.Refer to the unit rating plate for voltage, minimum circuit ampacity and over cur- rent protection requirements.
rating plate
3.Use only HACR type breakers or time delay fuses. Select the wire size accord- ing to the ampacity rating.
4.To access electrical connections and wiring diagram:
a)Remove the screws on the side panel adjacent to the back panel.
b)The screws adjacent to the front panel should already be loose (don't remove them).
c. Slide the side panel out to access the high/low electrical connections and wire diagram.
Note: Remove the plastic edge guards from the holes and replace with a water- tight strain relief fitting (High V) and a split grommet fitting (low V)
5.Power should be run to a weather proof disconnect box usually within 3 feet of the unit.
6.From the disconnect box, run the power through the 7/8" hole on the side of the unit and into the electrical box and an- chor with the strain relief fitting.
7.Run wires to the high volt pigtail in the con- trol box and attach L1 and L2 connections. Also run green wire to ground wire.
5 | www.enviromaster.com |
