Empire Comfort Systems DVD42FP5 Maximum Horizontal Run With No Vertical, RISE AND 90 ELBOW

	A
CENTER	OF ELBOW
		OUT
STRAIGHT
(MINIMUM)

Figure 23

MINIMUM HOLE LOCATION DIMENSIONS FOR THROUGH THE WALL HORIZONTAL INSTALLATIONS WITH 90 DEGREE ELBOW OFF TOP OF FIREPLACE

FIREPLACE	HARD ELBOW DIMENSIONS
SERIES	"A"	"B"	"C"
DVD32FP	41-1/2"	4"	6" (152mm)
	(1054mm)	(102mm)
DVD36FP	41-1/2"	4"	6"
	(1054mm)	(102mm)	(152mm)
DVD42FP	43-1/2"	4"	6"
	(1105mm)	(102mm)	(152mm)
DVD48FP	43-1/2"	4"	6"
	(1105mm)	(102mm)	(152mm)
FIREPLACE	FLEX PIPE 90 DEGREE BEND
SERIES	"A"	"B"	"C"
DVD32FP	43"	4-1/2"	6-1/2"
	(1092mm)	(114mm)	(165mm)
DVD36FP	43"	4-1/2"	6-1/2"
	(1092mm)	(114mm)	(165mm)
DVD42FP	45"	4-1/2"	6-1/2"
	(1143mm)	(114mm)	(165mm)
DVD48FP	45"	4-1/2"	6-1/2"
	(1143mm)	(114mm)	(165mm)

Positioning the Fireplace

Determine the exact position of the appliance so the direct vent termination will be centered (if possible) between two (2) studs. This will avoid any extra framing. All vent kit pipes should be assembled on the unit after the unit is moved into the final position.

Cutting the Hole (Figures 23)

After the fireplace has been positioned in its permanent location, the hole through the exterior wall of the house can be cut. This hole must be 10" (254mm) high x 10" (254mm) wide with its center line determined by the amount of vertical rise and horizontal run of the termination. (See Figure

23)When locating the hole it must be noted that the bottom of the cap must be 12" (305mm) above the ground level, and top of the cap must be no less than 18" (457mm) below a combustible projection, and no closer than 9" (229mm) to any wall running parallel to vent termination. (See Figure 24)

23552-1-0607

minimum

Figure 24

MAXIMUM HORIZONTAL

RUN WITH NO VERTICAL

RISE AND 90° ELBOW

MAXIMUM HORIZONTAL RUN WITH MINIMUM VERTICAL RISE AND 90° ELBOW

Figure 25

Page 17