Energy Tech Laboratories EDP70 manual MI00/10056 rev.1--05/2001

S5 = RESERVE OUTPUT switch

S4 = INVERTER OUTPUT Breaker

S3 = BY PASS switch

S2 = Equipment RESERVE switch

S1 = Equipment ON/OFF Breaker

Output, Input, Reserve

and External Battery Terminals

Access plate

Figure 23 – 50/80kVA: Connections

Access to the terminals for electrical connections is as follows:

a)Remove front panel see Figure 20.

b)Remove the terminal board compartment panel by unscrewing the fixing screws at the front.

e)This exposes the electrical terminal rail, see Figure 21

f)Remove the screws securing the access plate.

e)Push the interconnection cables up through the access plate.

f)Release the terminal securing nuts by unscrewing fully anti-clockwise. All cables must be terminated with the correct size lugs and connected on the bottom side terminals as marked.

g)Install or start-up batteries see section 13.3 and 13.4.

h)Replace and tighten the terminal securing screws fully clockwise and refit the access plate.

i)Replace the terminal board compartment panel and the front cover.

OBSERVE POLARITIES AND ORIENTATIONS.

See Remote Alarms and Computer Interface for connections to these facilities.

page 36 --MI00/10056 rev.1--05/2001