Enterasys Networks A2H124-24P, A2H124-48P manual Lanview LEDs, Color State Recommended Action

Using LANVIEW

Note: The terms flashing, blinking, and solid used in Table 4-1indicate the following:

Flashing: LED is flashing randomly.

Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).

Solid: LED is on steady and not pulsing.

Table 4-1 LANVIEW LEDs

LED	Color	State	Recommended Action
CPU	Off	Power disconnected.	If the LED remains off after connecting AC
			power or DC power from an RPS, check
			the following:
			1. Make sure there is power at the power
			source (AC source and RPS if
			applicable).
			2. Replace the power cord with a known
			good one or check the continuity of the
			power cord.
			3. If the SecureStack A2 still does not
			power up, the system may have a fatal
			error. Contact Enterasys Networks for
			technical support.
	Red	Solid. Boot-up failed.	If the LED remains red for several
			minutes, the system may have a fatal
			error. Contact Enterasys Networks for
			technical support.
		Blinking. Diagnostics have	Contact Enterasys Networks for technical
		failed.	support.
	Amber	Solid. Diagnostics are running. If the LED remains amber for more than
			several minutes, contact
			Enterasys Networks for technical support.
		Blinking. Code image is being	None.
		downloaded.
		This also notes when the
		configuration is being saved to
		member units. (This occurs
		every 15 minutes and when the
		user enters the “save config”
		command).
	Green	Solid. System is fully	None.
		functional.
		Blinking. Boot-up in process.	None.

SecureStack A2 PoE Installation Guide 4-3