Enterasys Networks XSR-3150 manual Port Adsl NIM Card Port, Figure A-23 Adsl NIM Card

Cable, CompactFlash and Accessory Specifications

1-Port ADSL NIM Card Port

The XSR’s Asymmetric Digital Subscriber Line (ADSL) NIM card, as shown in Figure A-23, provides 1 WAN port on an ADSL over POTS (Annex A/C) or ISDN (Annex B) line with a 6-pin RJ-11 connector. The ADSL NIM supports both G.dmt and G.lite standards. ADSL NIMs are shipped with a CompactFlash card containing DSP firmware. This driver software copies the Flash file into host memory where it provides on-demand use by the DSP.

	Figure A-23 ADSL NIM Card
LED 1	LED 2

Note: The XSR supports only one ADSL card type at a time, so multiply-installed card types must be similar.

The LEDs behave as follows: LED 1 - Status - When OFF, the line is down; when ON; the line has ended “training” or synchronization with the remote DSLAM device and is operational; when Flashing, the line is in training mode; LED 2 - Data - When flashing, traffic is active.

Refer to Figure A-24for pinout assignments.

		Figure A-24 ADSL NIM Pinouts
				Pin	Signal
	ADSL
				1	Unused
Pin 1			Pin 6	2	Unused
				3	Signal (Tip)
				4	Signal (Ring)
				5	Unused
				6	Unused

Regulatory/Safety Compliance

The ADSL NIM complies with the following regulatory requirements: EN 55022, EN 55024, FCC Part 68, CS03, TIA/EIA-IS-968, T1.413, ITU G.992.1, ITU G.992.2, ITU G.991.2, ITU G.994.1, Deutsche Telecom U-R2 specifications and ANSI Standard T1.413-1998 (issue 2) specifying full rate ADSL.

The ADSL NIM also complies with the following safety requirements: UL 1950, CSA No. 950, EN 60950, and IEC 950 (CB Scheme Report).

XSR Getting Started Guide A-19