Hopper Cover Screw Placement | Enviro Meridian manual

Installation

Figure 15: Hopper Cover Screw Placement.

MOBILE HOME INSTALLATION - FREESTANDING:

Figure 16: Hopper Extension Screw Placement.

●Secure the heater to the floor using the holes in the pedestal of the appliance.

●Ensure the unit is electrically grounded to the chassis of your home (permanently).

WARNING: Do not install in a room people sleep in.

CAUTION: The structural integrity of the manufactured home floor, wall and ceiling/roof must be maintained

•Outside fresh air is mandatory. Secure outside air connections directly to fresh air intake pipe and secure with three (3) screws evenly spaced.

Hearth Pad

Flooring

Steel Frame

	1/4" Lag bolts	Ground wire directly
		connected to metal chassis.
	securely fastened

Figure 17: Mobile Home Install Mounting.

15

Image 15

Enviro Meridian owner manual Hopper Cover Screw Placement

Contents

Meridian Table of Contents I. Pellet Standards Introduction USE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Circuit Board Control Panel Decal Operating Instructions Initial START-UP See above Thermostat / Switch Mode Burn POT and Liner 2-3 days Routine Cleaning and MaintenanceTools Required to Clean Unit Door Glass Cleaning 2-3 days Do not Place Unburned or RAW Pellet Fuel in ASH PAN Firebox Panel Installation of firebox backingPost Season CLEAN-UP Cleaning Plated Surfaces Removing Freestanding Stove From the Pallet Installation 32 1/2 826mm 24 7/8 24 3/4 632mm 629mm Meridian on Floor Optional Hopper Cover Screw Placement Exhaust Freestanding InsertFresh AIR Intake Crawlspace, narrow Walkway Closely Installation Pipe Must Extend Least Cm away Elbow with a rodent screen may be used Inside Vertical Installation Outside Vertical Installation Hearth Mount Side View Exterior Exhaust Blower Exhaust Blower Installation Horizontal Termination To Supply Power to the Exhaust Blower Exhaust Blower Installation Vertical Termination Before starting installation Noncombustible Hearth Pad Removal Wiring harness from the bottom of the circuit board control Surround in then down to Tools Required Removal of Louver BAR SET Clean all plated surfaces before starting the stove. See Pin Placement on Circuit Board Hole for Pressure test with Special Notes What to do if TroubleshootingStove will not operate when hot Do not Light # 2 on Heat output bar flashing Exhaust motor will not function normally Ignitor- the pellets will not light 200 F 93 C high limit temperature sensor has trippedControl settings Heat Level has no effect on the fire Convection blower will not function normally 5V DC Wiring Diagram Reference Number Description Part Number Parts List Louver Bar Set Gold Meridian Freestanding Steel Parts Parts Diagram Insert Steel Parts Diagram Components Warranty To the DistributorFor the do-it-yourself Individual Name of Owner Address Installation Data Sheet