Enviro Meridian owner manual To Supply Power To The Exhaust Blower, Installation

Installation

NOTE:

Ensure that all vent connections are installed by placing three (3) screws evenly spaced and a small bead of high temperature silicone at each chimney connection. Also ensure that all vertical vent sections are properly supported and that all clearances to combustibles are maintained in accordance with the vent manufacturer’s specifications.

Siding
Vent termination cap
(stainless steel termination	90° elbow
hood) or 45° elbow with
rodent screen
Wall strap	Wall framing
(recommended with
use of vent pipe)
Vent pipe or 2 foot
(610 mm) riser
Pipe adapter (if	Wall thimble
using 2 foot riser)
Exterior blower
and housing
Horizontal frame
for thimble
Armour cable supplying
power to exterior blower
	ENVIRO Meridian

Figure 32: Exhaust Blower Installation; Horizontal Termination.

TO SUPPLY POWER TO THE EXHAUST BLOWER:

Install an amour coated electrical cable from the exhaust blower housing, through the wall thimble, and attach to the pre-drilled hole in the left hand rear hopper pillar. Hook up to wires from the wiring harness for the exhaust blower. All electrical connections must be in accordance with local code requirements (see

WIRING DIAGRAM).

25