Installation

PLATED TRIM INSTALLATION:

TO AVOID PERSONAL INJURY DO NOT REMOVE OR REPLACE TRIMS WHEN PELLET STOVE IS HOT!

KIT COMPONENTS:

Quantity

Description

 

 

2

Upper Cabinet Trim

 

 

2

Lower Cabinet Trim

 

 

1

Top Trim

 

 

3

Louver

 

 

4

#8 nut plated (spares)

 

 

TOOLS REQUIRED:

T-20 screwdriver ●11/32” socket

Upper

Cabinet Trim

Lower

Cabinet Trim

#8 Hex Nut (x8)

Left Cabinet

Side

#8 Stud (x8)

Figure 43: Right cab side with upper and lower cabinet trims.

REMOVAL OF SIDE TRIMS:

When stove is off and cool, open the door. Remove the two (2) screws on the right cab side (at top and bottom of front flange) and the two (2) screws on the left cab side (one above and one below hinge). The cab sides have hinges at the back so they can swing open when the screws have been removed.

Remove the trims that will be replaced by unfastening the #8 hex nuts (four (4) for each piece of trim) by hand. Carefully remove the trim from the studs.

REPLACEMENT OF SIDE TRIMS:

Top Front

 

Place the new trim pieces on their corresponding studs

 

and finger tighten the #8 hex nuts (four (4) for each

 

piece of trim). Refer to Figure 43.

 

Close both cab sides and replace the two (2) screws on

#8 Stud (x6)

each side.

Top Trim

REMOVAL OF TOP TRIM:

 

With door open, undo the two (2) screws on the

#8 Hex Nut (x6)

underside of the top there are visible under the angled

corners. Open the hopper lid, remove the two (2) screws

Hand Tighten Only

Figure 44: Top front with top trim

that are found attached to the top under the hopper lid.

 

Pull top forward, lift the top front piece off the stove and turn it over. Remove the six (6) #8 hex nuts and pull the trim off the studs.

REPLACEMENT OF THE TOP TRIM:

Place the new trim on its corresponding studs (see Figure 44) and finger tighten the six (6) #8 hex nuts.

Replace top front on top of the stove, remembering to hook the two (2) front tabs under the corresponding tabs on the stove. Replace the two (2) screws on the top under the hopper lid then close lid. Replace the

30

Page 30
Image 30
Enviro Meridian owner manual Tools Required