Operating Instructions
TIMER MODE – (appliance must be in standby mode; pilot ignited): The Timer setting allows
you to set two (2) burner | times and two (2) burner | times every 24 hours. | ||
For | to operate as a thermostat, TEMP must be set at 40°F (4.5°C) or higher. | |||
If the | setting is decreased to | |||
in the moon times and await the next burner | cycle. |
| ||
NOTE: The display shows the set temperature every 30 seconds.
Changing the Mode of Operation
Briefly pressing the SET button changes the mode of operation in the following order: 
and back to
NOTE: MAN mode can also be reached by pressing either the (up arrow) or the (down arrow).
“MAN” Mode - Manual Flame Height Adjustment
1.Press 
(up arrow) to turn on the main burner.
2.Press 
(up arrow) to increase the flame height.
3.Press 
(down arrow) to decrease the flame height or to go to pilot standby position.
NOTE: While pressing either button a symbol indicating transmission appears on the display. The receiver confirms transmission with an acoustic signal.
Setting the Temperature
1. Select either the | MODE or the | MODE by briefly pressing the SET button. |
2.Hold the SET button until the TEMP display flashes.
3.Set the desired temperature with (up arrow) or (down arrow). NOTE: 4.5°C/40°F is the min. temperature setting.
NOTE: If you would like the Nighttime Setback temperature control to turn off, decrease the nighttime temperature until
Setting the Timer
1.Select Timer mode by briefly pressing the SET button.
2.Press and hold the SET button until “TIMER” is displayed on the lower right hand side.
3.Press and hold the SET button until the P1 (sun symbol) and the time display flashes. Set the hour by pressing the
(up arrow) and set the minutes by pressing the
(down arrow).
4.Briefly press SET button for the next burner cycle time. Example: P1 (moon symbol) continue through P2 (sun symbol) and P2 (moon symbol).
5.Once all four (4) times are set, press OFF or simply wait to complete programming.
CONTROL PANEL:
Press the larger flame to increase flame height. Press the smaller flame to decrease flame height. For fine adjustment tap the appropriate flame icon. Refer to Figure 4. Can also be use to turn unit on or off.
9
