Enviro Sonnet, C-11089 owner manual Trouble Shooting, Problem Possible Cause Solution

Trouble Shooting

Problem	Possible Cause	Solution
No transmissions;	Receiver must learn new	• Reset the receiver’s code, refer to MAINTENANCE
remote control	code.	AND SERVICE - CHANGING REMOTE HANDSET CODE.
doesn’t work.
	One or more of the	• Replace the batteries, refer to MAINTENANCE AND
	batteries are dead.	SERVICE - REPLACING THE BATTERIES.
	The receiver is surrounded	• Change the position of the antenna.
	by metal, reducing the	WARNING: Make sure that the antenna is not
	transmission range.
		too close to the electrode cable and ignition coil
		(beneath the cover). It will damage the receiver
		(see Figure 78).

		Figure 78: Receiver’s Antenna
		Position.
	Receiver is malfunctioning.	• Replace receiver and reprogram code, refer to
		MAINTENANCE AND SERVICE - CHANGING REMOTE
		HANDSET CODE.
	Transmitter is	• Replace transmitter and reprogram code, refer
	malfunctioning.	to MAINTENANCE AND SERVICE - CHANGING REMOTE
		HANDSET CODE.
	Wiring at the valve has	• Replace the valve.
	been damaged.
	Pins on 8 wire connector	• Straighten the pins on the 8 wire connector.
	have been bent.
	Gas control valve is turned	• Turn the gas valve ON.
	OFF.
	Pilot has gone out.	• Relight the pilot
No ignition; no tone.	Receiver	• Replace the receiver and reset the receiver’s
		code, refer to MAINTENANCE AND SERVICE -
		CHANGING REMOTE HANDSET CODE.
No Ignition; One 5	Loose wire.	• Check and secure all wires
second continuous
	Receiver	• Replace the receiver and reset the receiver’s
tone (7 short beeps		code, refer to MAINTENANCE AND SERVICE -
might be heard prior		CHANGING REMOTE HANDSET CODE.
to the 5 second
	Pins on 8 wire connector	• Straighten the pins on the 8 wire connector.
tone).
	have been bent.
	Valve.	• Replace the valve.

36