Operating Instructions
For Your Safety, Read Safety Precautions And Lighting Instructions Before Operating
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OF LOSS OF LIFE.
LIGHTING AND TURNING OFF INSTRUCTIONS:
CAUTION: Hot while operating. Do not touch, severe burns may result. Keep children, clothing, furniture, gasoline or other flammable vapors away.
CAUTION: Do not operate this fireplace with the glass removed, cracked or broken. Replacement of the panel should be done by a licensed or qualified person! This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air. Keep burner and control compartment clean. See installation and operating instructions accompanying appliance.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage, or loss of life. Refer to owner's information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or the gas supplier. Installation and service must be performed by a qualified installer, service agency, or the gas supplier.
FOR YOUR SAFETY READ BEFORE OPERATING 
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A)This appliance has a pilot which must be lighted by hand. When lighting the pilot, following these instructions exactly.
B)BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS: Do not try to light any appliance. Do not touch any electrical switch: do not use any phone in your building. Immediately call your gas supplier from a neighbor's phone. Follow the gas suppliers instructions. If you cannot reach your gas supplier, call the fire department.
C)Use only your hand to push in or turn the gas control knob; NEVER use tools. If the knob will not push in or turn by hand, do not try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D)Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS 
1.STOP! Read the safety information above on this label.
2.Set thermostat to its lowest setting.
3.Turn off all electrical power to this appliance.
4.Turn main valve OFF by pushing the on/off button on the remote handset
or on the control panel or alternatively, by turning the knob clockwise 
.
5.Wait five (5) minutes to clear out any gas. If you smell gas STOP! Follow “B” in the above safety information. If you do not smell gas go to the next step.
6.Ignite the unit by:
a. Simultaneously press and hold the star | and up arrow buttons on the | |
remote handset or just the ON/OFF | button on the control panel until a short | |
acoustic signal confirms the start sequence has begun; release button(s). Continuing signal confirms the ignition sequence is in process.
OR
b.If igniting the unit manually, turn the main valve ON by turning
the knob counter clockwise 
. Push in the solenoid and light the pilot. Flame height can be adjusted manually by turning the hi/low knob.
NOTE: Once pilot ignition is confirmed the main gas will flow. If the pilot will not stay lit after several tries, press OFF button on the remote handset or control panel, or turn the main gas valve knob) to OFF and call your service technician or gas supplier.
7.Turn on the electrical power to the appliance.
8.Set thermostat to desired setting or use the remote handset or control panel to adjust flame. Press up arrow to increase flame height, press down arrow to decrease flame height or set appliance to pilot flame. For fine adjustment tap the up/down arrows.
TO TURN OFF GAS TO APPLIANCE 
1.Set the thermostat to lowest setting or press OFF button on remote or control panel.
NOTE: Turn off all electrical power to this appliance if service is to be performed. Follow |
|
appliance manufacturer’s instructions for gaining accessibility to the gas control. |
Figure 3. Lighting instruction label.
|
| ON |
|
|
| OFF |
|
Low / Off / High | Smaller | On/Off | Larger |
Fan Rocker Switch | Flame |
| Flame |
Figure 4. Control panel.
The Sonnet can be controlled either with the control panel on the bottom left corner of the unit or with the handset remote control.
Figure 5. Ignition assembly.
7
